for Flipper Zero Modification Module,2.4G Module Expansion Board Support NEF Sniffer/Mousejacker, CC1101 Module,Module Accessories WiFi Multiboard

A10 board with esp32- module and SD card slot. Works and well priced. I was worried when it came in an envelope without a protective box- but it works. The USB-C connector has full functionality and connects well to a pi and GPIOThe RGB light is a 3 setting switch. It means nothing and only shows that the device is getting power. It could be less bright, or even a LED... Personal preference.

Product worked as written Love it

Product well made lights are pretty blinding would be nice to beable to order case for it. Been trying for a bout a week no good video explaining how to do it on you tube very frustrated taking up alot of time trying to figure it out. CAN SOMEONE PLEASE MAKE A GOOD VIDEO ON HOW TO DO THIS THANKS

I love it

The GINTBN for Flipper Zero Modification Module offers versatile support for NEF Sniffer/Mousejacker, CC1101 Module, and WiFi Multiboard. The 2.4G Module Expansion Board enhances the functionality of the Flipper Zero, providing users with a range of module accessories for customization. Overall, this product seems to provide a comprehensive expansion capability for those looking to enhance their Flipper Zero experience.

I can’t get this recognized even after updating USB drivers. Sometimes, holding down both boot and reset while plugging into USB and through the entire process, it will erase, but then it errors out, never transferring the software. Hell on that thumb.esptool.py v4.1Serial port COM3Connecting...Chip is ESP32-S2R2Features: WiFi, No Embedded Flash, Embedded PSRAM 2MB, ADC and temperature sensor calibration in BLK2 of efuse V2Crystal is 40MHzMAC: 70:04:1d:fa:d2:d6Uploading stub...Running stub...Stub running...Changing baud rate to 921600Changed.Erasing region (may be slow depending on size)...Erase completed successfully in 0.4 seconds.Staying in bootloader.Update: the board is now recognized but still errors out:PermissionError(13, 'A device attached to the system is not functioning.', None, 31)any suggestions

this thing showed up a little sooner than it was expected. It was packaged in great condition. I literally pulled it out of the package, connected the antennas and plugged it in. It worked immediately with the momentum firmware. I am very pleased for the price.

Its works !